Soudaseal 2K
Product Description
Product:
Soudaseal 2K is a fast curing high quality two component Hybrid Polymer based adhesive/sealant For use in elastical bonding applications where fast curing is required or for those applications where the bond design does not allow the normal penetration of atmospheric moisture.
Download Technical Data Sheet Download Safety Data Sheet
Description:
Soudaseal 2K cures by means of a chemical reaction between A and B component and therefore is not dependent on (atmospheric) moisture. Fully cured, an elastic and non-shrinkable adhesive layer is formed, which is moisture and heat resistant. The adhesive has excellent adhesion to practically all common substrates used in the construction and building industry.
Characteristics:
- Fast strength build-up
- Fast curing
- High performance mechanical properties
- Permanently elastic after curing
- Does not contain isocyanates, silicone, solvents
- Cures without the presence of atmospheric moisture
- For indoor and outdoor use
Applications:
Soudaseal 2K is suitable for elastic bonding and sealing applications in industrial, automotive, marine as well as construction and building areas
- Elastic bondig between metal surfaces, coated surfaces and many plastics (not PE, PP, Teflon)
- Elastic high performance bonding, both interior and exterior
- Elastic bonding applications in car, coach, caravan, marine, train, industries where fast curing and strength build-up is required
- Full surface bonding of non porous (sheet) material and large areas which are not porous enough to let atmosperic moisture through.
Bonding:
Soudaseal 2K has excellent adhesion on many surfaces. The following metal surfaces have been tested:, AlCuMg1, AlMgSi1, AlMg3, Al99, Brass, Electrogalvanized Steel, Firegalvanized Steel, Steel ST1403 and Stainless Steel. Plastics that were tested include: polystyrene, polycarbonate (Makrolon), polyamide (PA6), glasfiber reinforced epoxy and polyester (GRP). While producing plastics very often releasing agents, processing aids and other protective agents (like protection foil) are used. These should be removed prior to bonding. For optimum adhesion the use of Surface Activator is recommended.
NOTICE: bonding plastics like PMMA (ie Plexi glass), polycarbonate (ie Makrolon or Lexan) in stress loaded applications can give rise to stress cracking and crazing in these substrates. The use of Soudaseal 2K is not recommended in these applications. There is no adhesion on PE, PP, PTFE (Teflon) and ABS.
